Tns 300 manual

Teile Component Parts Composants Montagehalterungssatz Mounting Bracket kit Kit de support de montage To be ordered separately. Die YAW-Sensorabdeckung entfer- nen. Remove the YAW sensor cover : Bolt 1x Cut the foam into 12 pieces as shown in the illustration. Remove the release paper of the earth plate and attach the butyl tape shown. Route the antenna wire as shown.

Die Halterung a des Computers mit einem Bolzen e befestigen, wie in der Abbildung gezeigt. Return all vehicle parts that have been removed to their original locations.

Wire Harness Installation Installation of GPS Antenna Page 6: Application Charts p. Page 7 p. Yaris RHD - 9 Remove the speaker grill : Hook 5x Fig. Remove the instrument panel speaker : Screw 2x Fig. Centre Fig. Page 21 Yaris P1 TNS Match the length of the vehicle harness ,speed sensor wire and wire har- ness , and fix them using a wire tie at mm from the end. See table below for correct connection.

Reconnect the connector Affix the wire harness to the vehicle using foam tape Fig. Page 25 Yaris P1 TNS Connect the vehicle side 10P connec- tor to the wire harness Tie up the excess part of the wire har- ness , reverse sensor wire , and speed sensor wire , and affix them to the vehicle using foam tape at the position shown. Posted June 4, Pipenslippers Posted June 4, Appreciated, Did check this 1st but due to advance in technology its like applying Playstation 2 manual to an atari console.

Have a bid in on a manual so will share the knowledge freely if successful. Not familiar with rules but assume copyright would prevent sharing the document itself? Join the conversation You can post now and register later. Reply to this topic Insert image from URL. Go to topic listing.